Gtco DrawingBoard V - Quick Start Guide Manuel d'utilisateur télécharger pdf

Contents

Verify that your DrawingBoard V package includes the following:

 DrawingBoard V digitizing tablet

 Transducer (corded or cordless pen,

4-button or 16-button cursor)

 Computer interface cable with 9-pin

connector for RS-232

 USB cable

 Power supply

 CD-ROM with Windows Drivers and

user’s manual

 Registration card

 Accessory tray*

 Mounting brackets*

 Two feet*

*For Large Format Digitizer Only

NOTE: Some digitizing applications (typically, non-Windows CAD applications where the

tablet is used solely as a digitizer with no mouse functions) may not require the use of the

TabletWorks software. To configure DrawingBoard V for use with a third-party application,

please refer to the installation instructions in the DrawingBoard V User’s Guide, or the

DrawingBoard V Help file.

NOTE: If your digitizing tablet came with a TabletWorks CD, install the software FIRST, and

then setup the hardware connections for USB or serial, following the instructions below.

Software Configuration

Software drivers provide the communication bridge between your software application and

DrawingBoard V. The GTCO CalComp by Turning Technologies-supplied TabletWorks CD

supports reduced functionality Wintab and TabCon-compatible applications. If you are not

sure about your application’s driver requirements, please contact your application vendor.

Installing the Driver

Insert the CD into the CD-ROM drive on your computer and follow the onscreen prompts to

complete the driver installation. If the CD does not autorun, click the Start button on the

Windows Task Bar and select Run from the menu. Type X:\setup.exe (X represents the CD

drive letter).

1 2 3

Contents Verify that your DrawingBoard V package includes the following:  DrawingBoard V digitizing tablet  Transducer (corded or cordless

Hardware Configuration Installing DrawingBoard V NOTE: Connect ONLY USB or serial – not both. RS-232 Serial Connection 1. Connect the corded

Page 3

USB Connection – With TabletWorks CD Only – 1. Connect the corded transducer – cursor or pen – to the appropriate jack on the digitizer’s Con

Pas de commentaire

Gtco DrawingBoard V - Quick Start Guide Manuel d'utilisateur