Gtco DrawingBoard V - Quick Start Guide Manuel d'utilisateur télécharger pdf (Page 2)

Hardware Configuration

Installing DrawingBoard V

NOTE: Connect ONLY USB or serial – not both.

RS-232 Serial Connection

1. Connect the corded transducer – cursor or pen – to the appropriate jack on the

digitizer’s Connector Panel. The connector is keyed and will fit only the correct jack.

Do not force it.

2. Attach the RS-232 serial cable to the serial jack on the Connector Panel. The

connector is keyed and will fit only the correct jack. Do not force it. Join the 9-pin

connector of the serial cable to the serial port on your computer.

3. Plug the power supply into an AC outlet. Connect the power supply to the

appropriate jack on the Connector Panel. Turn the power switch on. The digitizer

will beep once, indicating it has power.

4. Restart your computer.

1 2 3

Pas de commentaire

Gtco DrawingBoard V - Quick Start Guide Manuel d'utilisateur Page 2