Gtco Super L III - Users Guide Manuel d'utilisateur télécharger pdf (Page 66)

Super L III 66

Table 13: Rate Commands

Point Mode

In Point Mode, one coordinate is sent when a transducer button is pressed. Output occurs

only when the transducer is in the active area.

To select Point Mode:

Tablet Configuration Utilities:

GTCO Commands:

Select the Point option under Mode.

Send command PT.

Line Mode

In Line Mode, coordinates are sent as long as a transducer button is pressed. Output

occurs only when the transducer is in the active area.

To select Line Mode:

Tablet Configuration Utilities:

GTCO Commands:

Select Line Mode.

Send command LN.

To set the rate at which coordinates are sent in Line Mode:

Tablet Configuration Utilities:

GTCO Commands:

Select 12, 50 or 100 under Rate.

Send command Rx (where x = 1-6), as

shown in Table 13.

1 2 ... 61 62 63 64 65 66 67 68 69 70 71 ... 75 76

Pas de commentaire

Gtco Super L III - Users Guide Manuel d'utilisateur Page 66