Gtco Super L III - Users Guide Manuel d'utilisateur télécharger pdf (Page 26)

Super L III 26

Resetting Super L III

There are four ways to reset Super L III:

 Enter SuperSet code 00 on the SuperSet Menu

 Turn the power switch off and back on

 Unplug and re-plug power supply

 Send remote commands described in the Advanced Operating Information section

When one of these events occurs, the Super L III will revert to the configuration that was

last defined. Any remote commands that were active before the reset will be lost.

Tablet Power/Proximity LED

The tablet led will be on when the tablet is on and transducer is awake and in the active

area.

Super L III Tones

Super L III produces an “alarm” in the form of audio tones to notify users of various events.

The table below describes the kinds of tones you may hear while operating the digitizer.

1 2 ... 21 22 23 24 25 26 27 28 29 30 31 ... 75 76

Pas de commentaire

Gtco Super L III - Users Guide Manuel d'utilisateur Page 26