Gtco Summagrid VII - Users Guide Manuel d'utilisateur

Summagrid VII 1

Summagrid VII 10 Hardware Configuration Summagrid VII must be configured so that it can send data in a way the application software will recognize a

Summagrid VII 11 USB Connection The Summagrid VII USB port connection is USB 1.1 and 2.0 compatible. When the digitizer is connected to the USB po

Summagrid VII 12 NOTE: Power is supplied through the USB port. No additional power source is needed for a USB installation, unless a high-accuracy

Summagrid VII 13  Stop Bits: Each character has one or two stop bits, which tell the receiving device that a character is complete. The number of

Summagrid VII 14 Mode Options  Mode: Defines how output reports are sent from the digitizer. Choices are: Prompt, Point, Switch Stream or Stream.

Summagrid VII 15 5. Once the Summagrid VI has been found on a Serial Port, select Advanced Configuration from the Options dropdown list

Summagrid VII 16 Setting the Tablet Switch Settings The Tablet Configuration Utilities provide an easy, interactive way to set the tablet switches u

Summagrid VII 17 Select either the Save Temporary Settings or the Save Power-Up Settings option from the File menu after you have set all the fun

Summagrid VII 18 Learning the Basics You will find that the Summagrid VII tablet is easier to use than a mouse. The Summagrid VII transducers are m

Summagrid VII 19 Lite Touch Pen The lite touch pen is available only in the cordless version. It is similar to the click tip pen, except that it ca

Summagrid VII 2 Table of Contents Introduction Parts Checklist What You Will Need to Use Summagrid VII PC Requirements For a Serial

Summagrid VII 20 Cleaning the Cursor To clean the cursor body, use a mild cleanser. Do not spray the cleanser directly on the cursor – instead, da

Summagrid VII 21 Replacing the Cordless Pen Batteries The pen requires two 393 silver oxide batteries. The average battery life is 200 hours. To r

Summagrid VII 22 Replacing the Cordless Cursor Batteries The cordless cursor requires two AAA batteries. The average battery life for the cursor ba

Summagrid VII 23 Troubleshooting GTCO CalComp by Turning Technologies wants your experience with Summagrid VII to be a successful one. If you ever

Summagrid VII 24 4. The cursor turns on again at the new frequency. You will know the cursor is on when the Indicator Light glows steadily. To ret

Summagrid VII 25 Computer Checklist  Is the computer plugged into a live outlet? Did you turn on the computer?  Does the computer work with any

Summagrid VII 26  If you are using a PC, did the new software alter your AUTOEXEC.BAT file?  Have you updated the software or its drivers?  Ar

Summagrid VII 27 Screen pointer appears to shake or jitter Unable to use the entire tablet surface Tablet is set too close to the screen monito

Summagrid VII 28 Parts and Accessories The following table lists the Summagrid VII systems and parts available for purchase. To order any of the it

Summagrid VII 29 Glossary Accuracy The similarity of a distance measured by the tablet with the actual distance. When we specify that the accuracy

Summagrid VII 3 Caring for the Tablet and Transducer Cleaning the Tablet Cleaning the Cursor Replacing the Pen Tip Replacing the

Summagrid VII 30 Data Rate Number of coordinate pairs (X,Y) the tablet sends to the computer per second. Default A value, action or setting that a

Summagrid VII 31 Line Mode The tablet sends coordinate data points continuously, while the pen tip or a cursor button is depressed, and one addition

Summagrid VII 32 Proximity Greatest distance above the Active Area that the transducer can be raised and still be sensed by the tablet. RAM Abbrevi

Summagrid VII 33 Regulatory Statements and Warranty Radio and Television Interference The user is cautioned that any changes or modifications not ex

Summagrid VII 34

Summagrid VII 35 Japan Bescheinigung des Herstellers/Importeurs Heirmit wird bescheinigt, dass der/die/das Summagrid VII (Geraet, Typ, Bezeichnung)

Summagrid VII 36 Einhaltung mit betreffenden Bestimmungen kommt darauf an, dass geschirmte Ausfuhrungen gebraucht werden. Fuer die beschaffung richt

Summagrid VII 37 Limited Warranty for Summagrid VII GTCO CalComp by Turning Technologies, Inc. warrants these products to be free from defects in m

Summagrid VII 38 3. Certain shipping charges. (Payment of shipping charges is discussed in the next section of this warranty.) 4. Packaging costs

Summagrid VII 39 Notice Some states and provinces do not allow the exclusion or limitation of incidental or consequential damages, so the above excl

Summagrid VII 4 Introduction Summagrid VII belongs to a class of computer input devices called graphics tablets, or digitizers. A digitizer is an e

Summagrid VII 40 Corporate Headquarters 14557 N. 82nd Street Scottsdale, Arizona 85260 Tel: 1-866-746-3015 Support: 1-866-746-3015 Fax: 480-998-

Summagrid VII 5 Parts Checklist  Summagrid VII digitizing tablet  Transducer (corded or cordless pen, 4-button or 16-button cursor)  Computer

Summagrid VII 6 For a USB Installation  Microsoft Windows 98 SE, ME, 2000 or XP  One available USB port  10 MB of free disk space  Applicati

Summagrid VII 7 Indicator Light The power/proximity LED in the upper right corner of the Summagrid VII frame is the Indicator Light. It remains off

Summagrid VII 8 Once software drivers, if needed, are installed, the hardware is configured. The corded transducer is connected, a power connection

Summagrid VII 9 Simply slide the Tray Rails into the channel and line up the hole in the tray with the hole in the T-Nut. Tighten the Thumb Screw t