Gtco QuikRuler - Users Guide Manuel d'utilisateur télécharger pdf (Page 9)

QuikRuler 9

When QuikRuler is shipped to you, it is programmed to expect the menu to be in the lower

left corner of the digitizer surface.

Relocating the Menu at Start-Up

When you start QuikRuler, it shows the following message for five seconds.

If you want the menu to be in a different location, you can relocate it when you start

QuikRuler.

 Select a place for the menu and tape it down. The entire menu must be within the

digitizer’s measuring area.

 Power up QuikRuler.

 Press the stylus tip anywhere when the Relocate Menu message is displayed.

 QuikRuler prompts you to Select Left Pnt.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 34 35

Pas de commentaire

Gtco QuikRuler - Users Guide Manuel d'utilisateur Page 9