Gtco CR 1212 - Configuration Manuel d'utilisateur

Changing the Configuration CR 1212 defaults to a certain operational configuration, baud rate and report rate. The operational configurations are

Disassembling the Tablet 1. Ensure the tablet is turned off and all cables, clips, etc. are removed. 2. Turn the tablet upside-down on a clean,

4. Turn the tablet on its side. Raise the tablet a few inches from the work surface. Rap it firmly on the work surface. This shifts the bottom

6. Turn the tablet on the other side and perform Steps 4 and 5. The top and bottom covers should pull away easily. If not, lay the tablet upside

Changing Jumpers Change the jumper caps as you wish. Configuration Jumper W5 Jumper W7 Jumper W8 Jumper W9 100 reports per second cap removed 7

Reassembling the Tablet 1. Turn the printed circuit board over so that the component side is not facing you. Holding the board at an angle, slide

3. Lay the tablet cover upside-down on the work surface as shown below. Ensure that the two posts are protruding through the green plate and the

4. Hold the bottom cover upside-down over the top cover. Slide the bottom edge of the bottom cover into the top cover so that the tabs fit into t