Gtco Surface-Lit AccuTab - Users Guide Manuel d'utilisateur télécharger pdf (Page 63)

Surface-Lit AccuTab 63

GTCO Commands:

Send command CL; to set a new increment

value, send command IV and at the prompt,

send three digits representing the new

increment in units of 0.001”.

Remote Request Mode

In Remote Request Mode, one coordinate is sent when the Controller receives a Read

Current Coordinate command (CTRL-B).

To select Remote Request Mode:

Custom Configuration Menu:

GTCO Commands:

Not available.

Send command RM.

Controlling the Alarm Using Remote Commands

An alarm (audio tone) is provided so the AccuTab can inform you of certain conditions. The

alarm can be enabled or disabled by the

Menu or commands.

To hear only critical tones, turn the alarm off:

AccuSet Menu:

GTCO Commands:

Select the Alarm menu block

Send command AD.

To hear all tones, turn the alarm on:

AccuSet Menu:

GTCO Commands:

Select the Alarm menu block.

Send command AE.

When you move the cursor over the Alarm block on the AccuSet Menu, the Proximity

indicator (green) will light if the alarm is currently enabled.

1 2 ... 58 59 60 61 62 63 64 65 66 67 68 69 70

Pas de commentaire

Gtco Surface-Lit AccuTab - Users Guide Manuel d'utilisateur Page 63