Gtco Surface-Lit AccuTab - Users Guide Manuel d'utilisateur télécharger pdf (Page 62)

Surface-Lit AccuTab 62

Continuous Mode

In Continuous Mode, coordinates are sent continuously, at the specified output rate.

Output occurs only when the transducer is in the active area. Output occurs continuously,

whether or not a transducer button is pressed.

To select Continuous Mode:

Custom Configuration Menu:

GTCO Commands:

Select the “Cont” option under Mode; select

12, 50 or 100 under Rate.

Send command CN; to select a rate, send

command Rx (where x = 1-6), as shown in

Table 13.

Line Incremental Mode

In Line Incremental Mode, one coordinate is sent when the transducer is moved farther

than a preset increment and a transducer button is pressed. Default increment is 0.01”.

Output occurs only when the transducer is in the active area.

To select Line Incremental Mode:

Custom Configuration Menu:

GTCO Commands:

Select the “Line Incr” option under Mode.

Send command IC; to set a new increment

value, send command IV and at the prompt,

send three digits representing the new

increment in units of 0.001”.

Continuous Incremental Mode

In Continuous Incremental Mode, one coordinate is sent when the transducer is moved

farther than a preset increment or a transducer button is pressed or released. Default

increment is 0.01”. Output occurs only when the transducer is in the active area.

To select Continuous Incremental Mode:

Custom Configuration Menu

Select the “Cont Incr” option under Mode.

1 2 ... 57 58 59 60 61 62 63 64 65 66 67 68 69 70

Pas de commentaire

Gtco Surface-Lit AccuTab - Users Guide Manuel d'utilisateur Page 62