Gtco Surface-Lit AccuTab - Users Guide Manuel d'utilisateur télécharger pdf (Page 42)

Surface-Lit AccuTab 42

Turn Status Indicator or Cursor Illumination On

Tone Status Indicator or Cursor Illumination Off

Code: ON

Code: OF

These commands control the state of the yellow status indicator on the 16-button cursor or

the cursor lamps on the illuminated cursor.

Diagnostic Commands

Transmit Version Number

Code: VR

Command causes AccuTab to determine and transmit the version number of the firmware

currently installed.

Display Tablet Active Area Size

Code: SZ

AccuTab automatically determines the size of the attached tablet’s active area when it is

turned on or reset. This command can be used to send the information to another device.

The size is encoded as four digits: two digits representing vertical size in inches followed by

two digits representing horizontal size in inches. For example, the 36” x 48” AccuTab sends

the digits 3648 in response to this command.

Read Tablet Diodes

Code: RD

Diagnostic command causes the AccuTab to examine the attached tablet and send the

results to another device for display. A “1” means a diode is present and a “0” means a

diode is missing.

1 2 ... 37 38 39 40 41 42 43 44 45 46 47 ... 69 70

Pas de commentaire

Gtco Surface-Lit AccuTab - Users Guide Manuel d'utilisateur Page 42