Gtco Summagrid VII - Quick Start Guide Manuel d'utilisateur télécharger pdf (Page 3)

3. Plug the power supply into an AC outlet. Connect the power supply to the

appropriate jack on the Connector Panel. Turn the power switch on. The digitizer

will beep once, indicating it has power.

4. Restart your computer.

USB Connection – With TabletWorks CD Only –

1. Connect the corded transducer – cursor or pen – to the appropriate jack on the

digitizer’s Connector Panel. The connector is keyed and will fit only the correct jack.

Do not force it.

2. Attach the USB interface cable to the USB jack on the Summagrid VII Connector

Panel. The connector is keyed and will fit only the correct jack. Do not force it.

3. Join the other end of the USB cable to any one of the USB ports on your

computer or USB hub. Turn the power switch on. The digitizer will beep once,

indicating it has power.

NOTE: Power is supplied through the USB port. No additional power source is needed for

this installation.

4. If Windows displays the Found New Hardware prompt, follow the onscreen

instructions to finish the Found New Hardware process.

1 2 3

Pas de commentaire

Gtco Summagrid VII - Quick Start Guide Manuel d'utilisateur Page 3