Gtco Summagrid IV - Users Guide Part 1 Manuel d'utilisateur télécharger pdf (Page 20)

Summagrid IV 20

4.2 Summagraphics Driver for Autodesk Applications

4.5.1 Introduction

There are two UIOF/Microgrid format drivers for Autodesk applications. Use these

drivers if AutoCAD has already been configured for a real or protected mode ADI

driver.

NOTE: Summagraphics’ ADI drivers are less likely to encounter initialization

problems when “shelling out” of AutoCAD, therefore, Summagraphics recommends

using the ADI drivers supplied on the Drivers/Utilities disk instead of AutoCAD’s

internal drivers.

Summagraphics provides both a real mode driver and a protected mode driver:

 DGMG.COM – Real mode driver for ADI™ (Autodesk Device Interface)

applications. This driver can be used on all DOS versions of AutoCAD.

 DGPMG.EXP – Protected mode driver for ADI version 4.2 supported

applications. Use this driver if you have a release 11 or 12 386 DOS extender

version of AutoCAD and wish to take advantage of AutoCAD’s protected

mode capabilities.

DGMG.COM and DGPMG.COM require tablet dip switches to be configured as follows:

Check Summagrid DIP switches to confirm the proper settings.

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 42 43

Pas de commentaire

Gtco Summagrid IV - Users Guide Part 1 Manuel d'utilisateur Page 20