Gtco Roll-Up II - Users Guide Manuel d'utilisateur télécharger pdf (Page 46)

Roll-Up II 46

Command Mode Basics

To enter GTCO CalComp by Turning Technologies Command Mode:

Send an ASCII CTRL-A (hex 01) character to the Roll-Up II. When the Roll-Up II receives the

CTRL-A, two things happen:

 Digitizing stops and new coordinates are not generated. If Command Mode is

invoked during transmission of a coordinate, that coordinate transmission will be

completed.

1 2 ... 41 42 43 44 45 46 47 48 49 50 51 ... 69 70

Pas de commentaire

Gtco Roll-Up II - Users Guide Manuel d'utilisateur Page 46