Gtco Cordless Roll-Up - Users Guide Manuel d'utilisateur télécharger pdf (Page 45)

Cordless Roll-Up 45

CalComp Emulation Commands

The Cordless Roll-Up recognizes a subset of the CalComp 9500 command set. Space does

not permit a detailed description of CalComp commands. However, most of the

commands in this subset have equivalent Cordless Roll-Up commands. For further

information about the operation of those commands, please refer to the Cordless Roll-Up

command or function description in the GTCO CalComp by Turning Technologies Cordless

Roll-up Command Summary.

NOTE: CalComp commands must be terminated with a <CR>, which is not shown in the

codes listed here. Commands can be strung together by substituting an @ character for

the <ESC>% sequence after the first command and postponing the <CR> until the end of

the multiple command string.

1 2 ... 40 41 42 43 44 45 46 47 48 49 50 ... 73 74

Pas de commentaire

Gtco Cordless Roll-Up - Users Guide Manuel d'utilisateur Page 45