Gtco Bit Pad Two - Users Guide Manuel d'utilisateur télécharger pdf (Page 26)

Bit Pad Two 26

 When the data tablet is in Remote Request and Increment modes, regardless of

whether the increment has been satisfied or not, the actual position where the

stylus or cursor is when the data tablet receives the remote trigger is reported

position.

 If Point or Remote Request modes are set by switch rather than by command, the

Report Rate, also set by switch, is valid. Consequently, the Report Rate has priority

over buttons or remote triggers.

Section C: Other Commands

Resolution

Command:

Switch Setting:

Resolution is the smallest distance or movement that the data tablet can distinguish. It’s a

measure of precision and is expressed in lines per inch (lpi) or lines per millimeter (lpmm).

NOTE: The data format and coordinate mode both play a role in which resolutions are valid

for the entire tablet.

1 2 ... 21 22 23 24 25 26 27 28 29 30 31 ... 47 48

Pas de commentaire

Gtco Bit Pad Two - Users Guide Manuel d'utilisateur Page 26