Gtco MM II 1201 - Users Guide Manuel d'utilisateur télécharger pdf (Page 55)

MM II 55

Reassembling the Tablet

1. Ensure that the printed circuit board has not shifted or lifted out of position. It

should be held gently in place by the two posts at the top edge.

2. Hold the bottom cover upside-down over the top cover. Slide the bottom edge of

the bottom cover into the top cover so that the tabs fit into the slots.

3. Snap the bottom cover down against the top cover. The bottom and side tabs

should be seated in the slots.

4. Replace the three cover screws. Gently tighten, but do not over tighten. Too much

pressure can strip the screw threads. Ensure that there is no gap between the top

and bottom covers.

1 2 ... 50 51 52 53 54 55 56 57 58 59 60 61

Pas de commentaire

Gtco MM II 1201 - Users Guide Manuel d'utilisateur Page 55